This page shows information about using flexVDI Dashboard to modify a Host that has been previously created with the flexvdi-config configuration tool.
You must be careful when configuring Hosts as a bad configuration can stop all the Guests running on it.
If you want to change these features, go to the Guest/Host/Pool section in the left part of the main window, select the Host and then open the drop-down menu. Select the "Modify" option.
A window with the following fields will be shown:
- Host description: a short description of the Host machine, intended usage, notes on it...
- Host address: name or IP address which will be used by flexVDI Manager and other Hosts in the infraestructure (if any) to access the Host and send requests.
- Host VDI Address: name or IP address which end users with flexVDI Client will use to reach the flexVDI Host to see and control their Guests. These users can be in a different network, behind a firewall, and access the Host through a different network interface. If in doubt, ask your network administrator.
- CPU Overcommit: This feature allows you to assign to your Guests more CPUs than the amount that is available in the Hosts. A value of 1 means that you can have as much total virtual CPUs in your Guests as physical CPUs you have in your Hosts. 2 means you can assign twice as much Virtual CPUs, and so on.
- RAM Overcommit: This feature allows you to assign to your Guests more RAM than what is available in the Hosts. The value in this field is the available/real ratio. Use this with care, as most other operating systems use all the RAM that is available in their hardware.
Once you have modified those values, press "Finish" in order to save the changes.